CAB 4712 Service Manual
Also see for 4712: Assembly instructionsOperator's manualService manual
                                                     | |
Contents
| 
40 406.16 Set Cylinder Peel Position / Actor 3.06.16.1 Set throttle valves on cylinder 'peel position'3.03ZX Y3.05Throttle valve (3.03) movement insidewith silencerClose throttle valve (3.03) completely.Turn the set screw clockwise until it stops.If no different value is noted in the test report, open the throttlevalve (3.03) by turning it 3 turns counterclockwise.Throttle valve (3.05) movement insideMarker on the tube with number 5Close throttle valve (3.05) completely.Turn the set screw clockwise until it stops.If no different value is noted in the test report, open the throttlevalve (3.05) by turning it 7 turns counterclockwise.Fig. 46 Throttle valve on the cylinder 'peel position'6.16.2 Set sensor on cylinder 'peel position'12 mm3.12Sensor (3.01) pad assembly in basic positionMarker on the sensor with number 5If no different value is noted in the test report,set the distance between the edge of the sensor (3.01) and theedge of the cylinder to 12 mm.As a check, switch on the printer and switch on compressed air.In the start position of the applicator, the LED on the sensor mustlight up. In this position, the pad assembly is at a maximum distancefrom the dispensing edge of the printer.When the cylinder extends and the pad assembly moves to thedispensing edge of the printer, the LED goes out.Fig. 47 Sensor on the cylinder 'peel position'6 Adjustments |
Related manuals for CAB 4712
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine