Chapter 5: Local Management5-646H123-50 and 6H133-37 User’s Guide5.18 SWITCH CONFIGURATION SCREENThe Switch Configuration screen, Figure 5-24, provides the basic setupoptions to customize switch operation in your network.Access the Switch Configuration screen from the Module ConfigurationMenu screen by using the arrow keys to highlight the SWITCHCONFIGURATION menu item and pressing ENTER. The SwitchConfiguration screen, Figure 5-24, displays.Figure 5-24 Switch Configuration ScreenDepending on the optional interfaces installed and if the device is a6H123-50 or 6H133-37, there can be 10 or 7 switched or network ports.Table 5-4 shows the CONN/port organization.NOTEThe Switch Configuration screen will not be available if theoperational mode of the module has been set to SECUREFAST VLAN. This screen may only be used by modulesconfigured to operate as 802.1D or 802.1Q switches.Firmware Revision: XX.XX.XXSwitch Configuration2276_18BOOTPROM Revision: XX.XX.XXPort #12345678StatelearninglisteningstandbylearninglisteningstandbylisteninglisteningModule Type: 6H123-50Slot Number:X6H123-50 LOCAL MANAGEMENTEvent Message LineRETURNSAVEMAC Address00-00-1D-00-00-0000-00-1D-00-00-0100-00-1D-00-00-0200-00-1D-00-00-0300-00-1D-00-00-0400-00-1D-00-00-0500-00-1D-00-00-0600-00-1D-00-00-07Status[ENABLED][DISABLED][ENABLED][DISABLED][ENABLED][DISABLED][ENABLED][ENABLED]Switch Address: 00-00-1D-00-00-00Number of Ports: 11Type of STA: [IEEE][9-11]Age Time (sec): [300]EXIT
