Chapter 5: Local Management5-686H123-50 and 6H133-37 User’s Guide5.18.3 Setting (Enabling or Disabling) the Port StatusTo set the status of an interface (port), proceed as follows:1. Use the arrow keys to highlight the Status field of the port.2. Use the SPACE bar to toggle to either ENABLED or DISABLED.3. Use the arrow keys to highlight the SAVE command at the bottom ofthe screen.4. Press ENTER. The message “SAVED OK” displays.5.19 MODULE SPECIFIC CONFIGURATION SCREENThe Module Specific Configuration screen, Figure 5-25, enables the userto select screens to configure ports or check system resources specific tothe 6H123-50 and 6H133-37.Access the Module Specific Configuration screen from the ModuleConfiguration Menu screen by using the arrow keys to highlight theMODULE SPECIFIC CONFIGURATION menu item and pressingENTER. The Module Specific Configuration screen displays.NOTEThe PORT REDIRECT FUNCTION menu item on the DeviceSpecific Configuration Menu screen does not display if theoperational mode of the device is set to 802.1Q SWITCHING.The PORT REDIRECT FUNCTION and BROADCASTSUPPRESSION menu items do not display if the operationalmode is set to SECURE FAST VLAN.Section 5.15.9 provides instructions on setting the operationalmode.
