Port Redirect Function Screen6H123-50 and 6H133-37 User’s Guide5-855.23.2 Changing Source and Destination PortsAdd or delete source port and destination port entries as follows:1. Use the arrow keys to highlight the Source Port field.2. Press the SPACE bar or BACKSPACE one or more times to incrementor decrement the port number displayed in the brackets [n] until theappropriate port number displays.3. Use the arrow keys to highlight the Destination Port field.4. Use the SPACE bar or BACKSPACE to step to the appropriate portnumber for the destination port.5. Use the arrow keys to highlight ADD or DEL in the Status field.6. Use the SPACE bar to set Status to either ADD or DEL (delete) andpress ENTER. This adds or deletes the port selections made in steps 2and 4 and also updates the screen Source Port and Destination Port list.7. Use the arrow keys to highlight ON or OFF in the Errors field.8. Use the SPACE bar to set Errors to either ON or OFF and pressENTER. ON forces the source port to forward errored frames to thedestination port(s). OFF forces the errored to be dropped beforeforwarding traffic.9. Use the arrow keys to highlight SAVE at the bottom of the screen.Press ENTER. The message “SAVED OK” displays. This saves thenew settings and updates the Source Port and Destination Portread-only fields.NOTEIf more than one port is to be redirected, repeat steps 1 through8 for each additional setting, then go to step 9 to save all thenew settings at once.
