Chapter 5: Local Management5-966H123-50 and 6H133-37 User’s Guide5.27.4 Enabling/Disabling Network PortsAll the network ports on a connector can be set to the same operatingmode simultaneously using the SET ALL PORTS field, as follows:1. Use the arrow keys to highlight the CONNECTOR # field.2. Use the SPACE bar to step to the appropriate connector number.3. Use the arrow keys to highlight the SET ALL PORTS field.4. Use the SPACE bar to step to the appropriate Operating Mode(Auto-Neg, 10Base-T, or 100Base-TX).5. Use the arrow keys to highlight the SAVE command.6. Press ENTER. The message “SAVED OK” displays and all networksof the connector are set to the selected operating mode.5.28 MODULE LEVEL SECURITY CONFIGURATIONThe Module Level Security Configuration screen, Figure 5-34, is used toset the state of security according to connector. All ports on a connectorcan be set to receive all frames (NonSecure state), lock on the sourceaddress of the next frame received (LockOnNext) or the source address ofthe last frame received (LockedOnAddr). When either of the last twooptions are set, the switch can be set to enable or disable the reception offrames and send or not send traps when an intruder is detected.To access the Module Level Security Configuration screen, use the arrowkeys to highlight the MODULE LEVEL SECURITYCONFIGURATION menu item on the Repeater Configuration Menuscreen and press ENTER. The Module Level Security Configurationscreen displays.
