Chapter 5: Local Management5-246H123-50 and 6H133-37 User’s Guide5.7.4 Setting the Chassis TimeTo set the chassis clock, perform the following steps:1. Use the arrow keys to highlight the Chassis Time field.2. Enter the time in this 24-hour format: HH:MM:SS3. Press ENTER to set the system clock to the time in the input field.4. Use the arrow keys to highlight the SAVE command at the bottom ofthe screen and press ENTER.If the time entered is a valid format, the Event Message Line at the top ofthe screen displays “SAVED OK”. If the entry is not valid, LocalManagement does not alter the current value and refreshes the ChassisTime field with the previous value.5.7.5 Entering a New Screen Refresh TimeThe screen refresh time is set from 3 to 99 seconds with a default of 3seconds. To set a new screen refresh time, perform the following steps:1. Use the arrow keys to highlight the Screen Refresh Time field.2. Enter a number from 3 to 99.3. Press ENTER to set the refresh time to the time entered in the inputfield.4. Use the arrow keys to highlight the SAVE command at the bottom ofthe screen and press ENTER.NOTEWhen entering the time in the system time field, separatorsbetween hours, minutes, and seconds do not need to be addedas long as each entry uses two numeric characters. Forexample, to set the time to 6:45 A.M., type “064500” in theChassis Time field.NOTEUpon saving the new chassis time, all interface modulesinstalled in the chassis recognize the new value as the currenttime.
