General Configuration Screen6H123-50 and 6H133-37 User’s Guide5-45Application (Toggle)Displays the application set for the COM port. This field enables you toset the application that the COM port supports. The field toggles betweenLM (Local Management) and UPS (Uninterruptible Power Supply).The UPS setting enables the COM port to be used to monitor an AmericanPower Conversion Uninterruptible Power Supply (UPS).The baud rate setting for LM is automatically sensed. For UPS, the baudrate is automatically set to 2400.For details about configuring the COM port for various applications, referto Section 5.15.11.Clear NVRAM (Toggle)This enables the user to reset NVRAM to the factory default settings. Alluser-entered parameters, such as IP address and community names arethen replaced with 6H123-50 and 6H133-37 default configurationsettings. For details, refer to Section 5.15.12.IP Fragmentation (Toggle)This field enables the user to enable or disable IP Fragmentation. Thedefault setting for this field is ENABLED. If the 6H123-50 and 6H133-37will be bridged to an FDDI ring, IP Fragmentation must be enabled. If IPFragmentation is disabled, all FDDI frames that exceed the maximumEthernet frame size will be discarded. For details on enabling or disablingIP Fragmentation, refer to Section 5.15.13.5.15.1 Setting the IP AddressTo set the IP address, perform the following steps:1. Use the arrow keys to highlight the IP Address field.2. Enter the IP address into this field using Decimal Dotted Notation(DDN) format.For example: 134.141.79.120NOTEIf the 6C105 chassis has been assigned an IP address, it is notnecessary to assign an IP address to the 6H123-50 and6H133-37. All installed modules have the same IP address asthe chassis. If a separate IP address for the module is desired,proceed as follows.
