Cabletron Systems CyberSWITCH CSX150 Quick Start Manual

Also see for CyberSWITCH CSX150: User guide User guide

Contents

Small Office Remote Access Switch 23BASICSMaking Configuration ChangesNote: Do NOT place more than one CyberSWITCH on a LAN with the default setting. With bothhaving the same IP address, unpredictable results will occur.You may also Telnet in via the WAN connection, however, how to set it up with the defaultconfiguration will not be described in detail in this guide. The general procedures are:1. Connect the system to the ISDN line.2. From a remote device that supports UnNumbered IP connections, dial in as a PPP CHAPdevice USER1 (USER1 as secret). The address on the CyberSWITCH to Telnet to is 1.1.1.1.3. From a remote device only supporting numbered IP connections, set up an IP Address 2.2.2.3and have it dial as a PPP CHAP device USER2 (USER2 as secret). The address on theCyberSWITCH to Telnet to is 2.2.2.2.After you make a Telnet connection, enter your login id and password. Then you will be presentedwith a system prompt and you can enter commands at that time.AMP CONNECTIONYou may use the AMP connection for local console access. With this type of access, use a directlyconnected PC, monitor, and keyboard to manage your CyberSWITCH. Refer to Cabling for AMPcabling instructions.L OGIN ON THE CYBERSWITCHOnce you have a connection to the CyberSWITCH, you will be presented with a prompt to enteryour log in id. Use admin as the login id. You will then be prompted for a new password, so choosea password that you will remember. If your software was previously accessed by your distributor,your password will be admin (in lower case).After you have logged in, you many enter any command at the system prompt.M AKING CONFIGURATION CHANGESWe provide three configuration tools to set up and/or alter your configuration. These tools are:• Set-Up Utility, the basic configuration utility, for basic configurations• CFGEDIT, the full configuration utility• Manage Mode, the dynamic management utilityUsing Set-Up Utility is a fast and easy way to configure your system. However, it was designed tohandle basic configurations, not for more complex configurations. If you have a more complexconfiguration, you may find it convenient to begin your configuration using our Set-Up Utility, getthe system up-and-running, then use the more robust CFGEDIT utility to fine tune yourconfiguration. The Set-Up Utility is located on the CD included with your CyberSWITCH.Instructions for installing and running the Set-Up Utility are in the pamphlet accompanying theCD.