Cabletron Systems CyberSWITCH CSX150 Quick Start Manual

Also see for CyberSWITCH CSX150: User guide User guide

Contents

Small Office Remote Access Switch 31BASICSInitial Installation StepsPHYSICAL RESOURCE CONFIGURATION1. Select Physical Resources from the main menu. Then, select Resource to display yourCyberSWITCH’s resources.2. If you are not using the default switch type, press 1 to change the switch type.3. Configure the WAN line. Select Data Line from the Physical Resources menu. After you selectto add a line you will be prompted for the line name. Enter LINE1 for the first line name.For line information:• select point-to-point for the interface type• add a data link (two for DMS and NI-1 switch types)• use Automatic TEIs for these data links• select voice and data as your mode of operation (this will work for all connection types, in-cluding POTS connections)For async modem port information• if you are using the AMP port for a null modem, enter “NULLMODEM”, if you are usingthe AMP port for a regular modem, enter a name you define for the modem• enter the baud rate• enter the data bits• enter the stop bits• enter the parity value• select the flow control type• select mode: either autosense or termIf you are unsure of any of the above values, use the default value. If the default does notwork, refer to your modem user documentation for their recommended values.4. If you are using any accesses besides switched accesses (such as dedicated accesses, frame relayor X.25) configure the access now. Select Access. Select the type of access you wish to configure.Follow the on-screen instructions to complete the configuration.Note: Frame relay and X.25 accesses are available only if you have purchased the additionalsoftware module for packet switched accesses.The initial configuration steps on the CyberSWITCH are now complete. Press repeatedlyuntil you return to the main CFGEDIT menu. Continue with the Connectivity section to completeremaining configuration steps.