ixContentsB.2.5 Creating an IP to NSAP Address Mapping ...........................................B-8B.2.6 Creating a Classical IP PVC .....................................................................B-9B.2.7 Creating a FORE IP PVC ARP Entry .....................................................B-9B.2.8 Displaying the ATM ARP Entries..........................................................B-10B.3 Switch Board Configuration Commands ....................................................... B-11B.3.1 Configuring the Clock Scaling Factor on a Switch Board.................. B-11B.3.2 Displaying the Board Configuration ....................................................B-12B.3.3 Displaying the Board Topology.............................................................B-13B.4 IP Configuration Commands...........................................................................B-14B.4.1 Configuring the IP Address ...................................................................B-14B.4.2 Configuring the IP State .........................................................................B-15B.4.3 Configuring the IP Broadcast Address .................................................B-15B.4.4 Configuring IP Forwarding ...................................................................B-16B.4.5 Configuring the IP Subnet Mask ...........................................................B-16B.4.6 Configuring IP Routes ............................................................................B-17B.4.7 Displaying the IP Interface Configuration...........................................B-19B.5 LAN Emulation Configuration Commands ..................................................B-20B.5.1 Broadcast and Unknown Server (BUS) Configuration Commands.B-20B.5.2 LAN Emulation Client (LEC) Configuration Commands.................B-24B.5.3 LAN Emulation Configuration Server (LECS) Commands ..............B-31B.5.4 LAN Emulation Server (LES) Configuration Commands .................B-36B.6 Network Module Configuration Commands................................................B-42B.6.1 Displaying Network Module Configuration Information ................B-42B.6.2 Configuring Distributed Timing on a Network Module ...................B-43B.6.3 Configuring Traffic on a Network Module..........................................B-48B.7 NSAP Configuration Commands....................................................................B-53B.7.1 NSAP Route Configuration Commands ..............................................B-53B.7.2 NSAP Prefix Configuration Commands ..............................................B-56B.7.3 NSAP ILMI Configuration Command .................................................B-59B.8 Port Configuration Commands .......................................................................B-60B.8.1 CDVT Port Configuration Commands.................................................B-60B.8.2 E-3 Port Configuration Commands ......................................................B-61B.8.3 TP25 Port Configuration Commands ...................................................B-66B.8.4 DS-3 Port Configuration Commands ...................................................B-68B.8.5 J-2 Port Configuration Commands .......................................................B-73B.8.6 Port Policing Configuration Command ...............................................B-76B.8.7 SONET Port Configuration Commands ..............................................B-77B.8.8 Showing the Port Configuration ...........................................................B-82B.8.9 TAXI Port Configuration Commands...................................................B-85B.8.10 Traffic Port Configuration Commands...............................................B-87B.8.11 VBROB Port Configuration Commands.............................................B-93B.8.12 VBRBuffOB Port Configuration Commands.....................................B-93B.9 Serial Port Configuration Commands ............................................................B-94B.9.1 Displaying Serial Port Information.......................................................B-94B.10 SNMP Configuration Commands .................................................................B-95B.10.1 Configuring the SNMP Community Access......................................B-95B.10.2 Configuring SNMP Traps.....................................................................B-95B.11 SPANS Configuration Commands ................................................................B-98B.11.1 Deleting a SPANS Signalling Path ......................................................B-98B.11.2 Creating a SPANS Signalling Path ......................................................B-99
