B-56AMI Configuration CommandsCost Shows the routing metric for this link. There is a costfor each link in a route. The sum of these link costsdetermines the overall cost of a route. To expeditetraffic on a route, the user should try to minimize theoverall cost of a route. A small cost value is assignedto a critical route, while a higher cost value isassigned to a lesser important route. The defaultvalue is 100.CBR Displays the maximum CBR capacity allowed forany single connection on this route. INF means thatuser did not specify a value for this parameter whenthe route was created, so the value defaults to thecapacity available on the outgoing link.VBR Displays the maximum VBR capacity allowed forany single connection on this route. INF means thatuser did not specify a value for this parameter whenthe route was created, so the value defaults to thecapacity available on the outgoing link.FLAGS A means this link supports ABR traffic. E means thatthis route supports Early Packet Discard (EPD). AEmeans this link supports both ABR traffic and EPD.No flags indicate that neither EPD nor ABR traffic aresupported on this link.B.7.2 NSAP Prefix Configuration CommandsThese commands enable the user to delete an NSAP prefix, create an NSAPprefix, and display NSAP prefix information. The user can display the list ofavailable subcommands by typing prefix ? at the nsap level.localhost::configuration nsap> prefix ?delete new show
