B-137AMI Configuration CommandsB.17.3 Displaying the UPC Traffic ContractsThis command lets the user display all of the UPC contracts. Enter the follow-ing parameters:localhost::configuration upc> showIndex PCR01 SCR01 MBS01 PCR0 SCR0 MBS0 CDVT Act EPD Name0 drop no default_ubr1 50 25 tag no cbr0_upc2 500 200 250 1000 drop yes vbr0_upcIndex Shows the UPC contracts listed by index number.PCR01 Shows the peak cell rate for all cells for this contract.SCR01 Lists the sustainable cell rate for all cells in this contract.MBS01 Lists the maximum burst size for all cells in this contract.PCR0 Shows the peak cell rate for cells with CLP = 0 forthis contract.SCR0 Shows the sustainable cell rate for cells with CLP = 0for this contract.MBS0 Shows the maximum burst size for cells with CLP = 0for this contract.CDVT Shows the Cell Delay Variation Tolerance (CDVT)associated with the peak cell rates, in microseconds.Act Tag means that non-compliant CLP = 0 cells aretagged. Drop means that non-compliant cells aredropped. This option only applies to cells measuredby the PCR0 parameter of the CBR0 contract and tocells measured by the SCR0 and MBS0 parameters ofthe VBR0 contract.EPD Yes means that EPD is enabled on this connection. Nomeans that EPD is not enabled on this connection.Name Shows the user-defined name associated with thisUPC traffic contract.NOTE: The units for PCR0, PCR01, SCR0, SCR01,MBS0, and MBS01 are shown either in cps orin kbps, depending on what you have config-ured for configuration system units. To dis-play the current setting, use configurationsystem show. The default is cps.
