B-42AMI Configuration CommandsB.6 Network Module Configuration CommandsThese commands let the user configure the network modules. The list ofavailable subcommands can be displayed by typing module ? at the config-uration level.localhost::configuration> module ?show timing> traffic>B.6.1 Displaying Network Module Configuration InformationThis command allows the user to display information about the configurationof the network modules that are currently installed in a particular switchboard. Enter the following parameters:localhost::configuration module> showModule Speed Ports Uptime Type4B 622.0 1 0d:17:58 NM-C-OC12c/STM4c-TIMING-SMIR-128KB-1PT (Rev. 1.0)4E 2560.0 4 0d:17:58 NM-ASX1000-BPSwitch Backplane Netmod (Rev. 1551712.1)The fields in this display are defined as follows:Module Shows each network module that is currently in theswitch board. The 4 means that it is the switch fabricin slot 4. B indicates the position of the physical net-work module in the switch fabric. E is the intra-fabricports to the other switch fabrics in the chassis.Speed Shows the speed in Mbps of the ports on the networkmodule.Ports Shows the number of ports on the network module.Uptime Displays the length of time that the network modulehas been in its current state.Type NM stands for network module. C is the series ofnetwork module. OC12c shows what kind of net-work module it is. TIMING means that it supportsdistributed timing. SMIR means singlemode inter-mediate reach. 128KB is the shared memory size. 1PTis the number of ports on the module. The E repre-sents the intra-fabric ports to the other switch fabricsin the chassis. Rev 1.0 is the hardware revision.
