C-4AMI Operation CommandsC.1.3 Resetting the DatabaseThis command enables the user to reset the configuration database. The onlyinformation that will be retained is the IP configuration which includes theswitch name and interface descriptions. The switch cautions the user that allATM information will be deleted. The switch then asks the user to confirmthat resetting the cdb is the desired action. Enter the following parameters:localhost::operation cdb> reset********** W A R N I N G **********This operation resets the switch configuration database.As a result, the switch control software will be restarted.You will lose connectivity with the switch while thisoperation is progressing.Are you sure you want to reset the CDB [n]? nlocalhost::operation cdb>If the user enters yes to the reset question, the switch responds as follows:Are you sure you want to reset the CDB [n]? yThe switch will restart momentarily.At this point, the switch resets the CDB, closes the user out of all active ses-sions, and restarts the switch. The user must then log in to AMI again to per-form any more actions on the switch.C.1.4 Restoring the DatabaseThis command allows the user to restore the configuration database. Enter thefollowing parameters:localhost::operation cdb> restore [:]host Specifies the IP address of the host on which the CDBfile that is to be restored resides.full path to backup file Indicates the full path name of the CDB file that is tobe restored.
