B-82AMI Configuration CommandsB.8.8 Showing the Port ConfigurationThis command lets the user display port information about all of the ports onan individual switch fabric or about just a specified port. To show generalinformation about all of the ports, enter the following parameters:localhost::configuration port> showPort Carrier Mb/s iVPs iVCs iBW oVPs oVCs oBw Model1C1 no 155.0 1 4 155.0 1 4 155.0 OC31C2 no 155.0 1 4 155.0 1 4 155.0 OC31C3 no 155.0 1 4 155.0 1 4 155.0 OC31C4 yes 155.0 1 4 155.0 1 4 155.0 OC31D1 no 155.0 1 2 155.0 1 3 0.0 OC31D2 no 155.0 1 5 155.0 1 4 155.0 OC31D3 no 155.0 1 4 155.0 1 4 155.0 OC31D4 no 155.0 1 4 155.0 1 4 155.0 OC31CTL yes 80.0 1 28 0.0 1 36 0.0 ASXThe fields in this display are defined as follows:Port Indicates the port number of the network modulesthat are currently installed in the switch fabric. CTLindicates the control port, which is a logical (notphysical) location where cells that are directed to theSCP itself are sent.Carrier Shows whether or not a carrier has been detected onthe port. If a carrier has been detected, yes is dis-played. If a carrier has not been detected, no is dis-played. A carrier is detected when a signal is appliedto the receive side of the port. It does not guaranteethe signal is the proper frequency.Mb/s Displays the capacity of this port’s link in Mbps.iVPs Shows the number of incoming virtual paths on theport.iVCs Indicates the number of incoming virtual channelson the port.iBW Lists the amount of bandwidth (in Mbps) that hasbeen reserved for the input link on the port.oVPs Designates the number of outgoing virtual paths onthe port.
