HeadlampsThe exterior lamp control is located in the middle ofthe turn signal/multifunction lever.O(Exterior Lamp Control): Turn the control withthis symbol on it to operate the exterior lamps.The exterior lamp control has four positions:O(On/Off): Turn the control to this position to turnoff all lamps and automatic lighting features includingDaytime Running Lamps (DRL) and IntelliBeam™.This is a momentary switch that springs back to theAUTO position when released. An AUTOMATIC LIGHTSON message appears on the DIC when automaticlights are enabled or an AUTOMATIC LIGHTS OFFmessage appears on the DIC when the automaticlights are disabled.AUTO (Automatic): Turn the control to this position toput the headlamps in automatic mode. AUTO mode,turns the exterior lamps on and off depending uponhow much light is available outside of the vehicle.Due to the switch design, the automatic lights may bedisabled even if the control is in the AUTO position.To enable automatic lighting do any of the following:• Turn the headlamp control from AUTO to offand release the switch. It returns back to theAUTO position by itself.• Turn the headlamp control from the parkinglamp position to AUTO.• Turn the headlamp control from the headlampposition to AUTO.To disable automatic lighting do any of the following:• Turn the headlamp control from AUTO to offand release the switch. It returns back to theAUTO position by itself.• Turn the headlamp control from AUTO to theparking lamp position.• Turn the headlamp control from AUTO to theheadlamp position.Disabling automatic lighting disables the automaticheadlamp operation, DRL, and IntelliBeam™High-Beams (if the vehicle has them).3-33
