15. If the flat tire was ableto inflate to therecommended inflationpressure, removethe maximum speedlabel from the sealantcanister.Place it in a highly visible location such as theinside of the upper left corner of the windshield orto the face of the radio/clock.The maximum speed label reminds you to drivecautiously and not to exceed 55 mph (90 km/h) untilyou have the damaged tire inspected and repaired.{CAUTION:Storing the tire sealant and compressor kit orother equipment in the passengercompartment of the vehicle could cause injury.In a sudden stop or collision, loose equipmentcould strike someone. Store the tire sealantand compressor kit in the proper place.16. Return the equipment to the proper storage locationin the trunk of your vehicle. You may need toloosen the retention strap to wrap it around thesealant and compressor kit and foam container.To do this, pull apart the strap and loosen the strapat the quick release buckle. Then snap the buckletogether, pull the strap tight, and secure theloose end of the strap by mating the ends.17. Immediately drive the vehicle 5 miles (8 km) todistribute the sealant evenly in the tire. Stop at asafe location and check the tire pressure, referto Steps 1 through 8 under “Using the AirCompressor without Sealant” next in this section.5-92
