Black plate (68,1)Cadillac SRX Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-7707476) - 2015 - crc - 9/5/1410-68 Vehicle Care16. If the flat tire was able to inflateto the recommended inflationpressure, remove themaximum speed label from thesealant canister (5) and place itin a highly visible location. Donot exceed the speed on thislabel until the damaged tire isrepaired or replaced.17. Return the equipment to itsoriginal storage location in thevehicle.18. Immediately drive the vehicle8 km (5 mi) to distribute thesealant in the tire.19. Stop at a safe location andcheck the tire pressure. Referto Steps 1–11 under “Using theTire Sealant and CompressorKit without Sealant to Inflate aTire (Not Punctured).”If the tire pressure has fallenmore than 68 kPa (10 psi)below the recommendedinflation pressure, stop drivingthe vehicle. The tire is tooseverely damaged and the tiresealant cannot seal the tire.See Roadside Service onpage 13-5.If the tire pressure has notdropped more than 68 kPa(10 psi) from the recommendedinflation pressure, inflate thetire to the recommendedinflation pressure.20. Wipe off any sealant from thewheel, tire, and vehicle.21. Dispose of the used sealantcanister (5) and sealant/airhose (6) assembly at a localdealer or in accordance withlocal state codes and practices.22. Replace with a new canisterassembly available from yourdealer.23. After temporarily sealing thetire using the tire sealant andcompressor kit, take thevehicle to an authorized dealerwithin 161 km (100 mi) ofdriving to have the tire repairedor replaced.Using the Tire Sealant andCompressor Kit withoutSealant to Inflate a Tire (NotPunctured)To use the air compressor to inflatea tire with air only and not sealant:
