Black plate (70,1)Cadillac SRX Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-7707476) - 2015 - crc - 9/5/1410-70 Vehicle Care8. Press and turn the selectorswitch (1) clockwise to the AirOnly position.9. Press the on/off button (2) toturn the compressor on.The compressor will inflate thetire with air only.10. Inflate the tire to therecommended inflationpressure using the pressuregauge (3). The recommendedinflation pressure can be foundon the Tire and LoadingInformation label. See TirePressure on page 10-48.The pressure gauge (3) mayread higher than the actual tirepressure while the compressoris on. Turn the compressor offto get an accurate reading. Thecompressor may be turned on/off until the correct pressure isreached.If you inflate the tire higherthan the recommendedpressure you can adjust theexcess pressure by pressingthe pressure deflationbutton (4) until the properpressure reading is reached.This option is only functionalwhen using the air onlyhose (7).11. Press the on/off button (2) toturn the tire sealant andcompressor kit off.Be careful while handling thetire sealant and compressor kitas it could be warm afterusage.12. Unplug the power plug (8) fromthe accessory power outlet inthe vehicle.13. Disconnect the air only hose(7) from the tire valve stem, byturning it counterclockwise, andreplace the tire valve stem cap.14. Replace the air only hose (7)and the power plug (8) andcord back in its originallocation.15. Place the equipment in theoriginal storage location in thevehicle.The tire sealant and compressor kithas an accessory adapter located ina compartment on the bottom of itshousing that may be used to inflateair mattresses, balls, etc.Removal and Installation of theSealant CanisterTo remove the sealant canister:1. Unwrap the sealant hose.
