Black plate (10,1)Cadillac SRX Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-7707476) - 2015 - crc - 9/5/142-10 Keys, Doors, and WindowsStarting the Engine Using RemoteStart1. Press and release Q on theRKE transmitter.2. Immediately press and hold /for at least four seconds or untilthe turn signal lamps flash. Theturn signal lamps flashingconfirms the request to remotestart the vehicle has beenreceived.During the remote start thedoors will be locked and theparking lamps will remain on aslong as the engine is running.The engine will shut off after10 minutes unless a timeextension is done or the ignitionis put in ON/RUN/START.3. With the remote in the vehicle,press the brake pedal and selectthe ON/RUN/START ignitionmode to drive.Extending Engine Run TimeThe engine run time can also beextended by another 10-minutes,if during the first 10 minutesSteps 1–2 are repeated while theengine is still running. An extensioncan be requested, 30 seconds afterstarting. This provides a total of20 minutes.The remote start can only beextended once.When the remote start is extended,the second 10-minute period isadded on to the first 10 minutes fora total of 20 minutes.A maximum of two remote starts,or a remote start with an extension,are allowed between ignition cycles.The vehicle's ignition must bechanged to ON/RUN/START andthen back to OFF before the remotestart procedure can be used again.Shutting the Engine Off After aRemote StartTo cancel a remote start, do any ofthe following:. Press and hold / until theparking lamps turn off.. Turn on the hazard warningflashers.. Turn the vehicle on and then off.Conditions in Which Remote StartWill Not WorkThe remote start will not operate ifany of the following occur:. The transmitter is in the vehicle.. The hood is not closed.. The hazard warning flashersare on.. There is an emission controlsystem malfunction.. The engine coolant temperatureis too high.. The oil pressure is low.
