Driving and Operating 9-21When first starting the vehicle,the engine idle speed will beelevated to allow the catalyticconverter, an emissions controldevice, to quickly reachoperating temperature. Afterapproximately 20 seconds, theengine will begin to transition toit's normal, quieter idle speed,which can vary depending onthe temperature. This is normaloperation.Notice: Cranking the engine forlong periods of time, by returningthe key to the START positionimmediately after cranking hasended, can overheat and damagethe cranking motor, and drain thebattery. Wait at least 15 secondsbetween each try, to let thecranking motor cool down.2. If the engine does not startafter 5‐10 seconds, especially invery cold weather (below 0°For −18°C), it could be floodedwith too much gasoline. Trypushing the accelerator pedal allthe way to the floor and holdingit there as you hold the key inSTART for up to a maximum of15 seconds. Wait at least15 seconds between each try, toallow the cranking motor to cooldown. When the engine starts,let go of the key and accelerator.If the vehicle starts briefly butthen stops again, do the samething. This clears the extragasoline from the engine. Do notrace the engine immediatelyafter starting it. Operate theengine and transmission gentlyuntil the oil warms up andlubricates all moving parts.Notice: The engine is designed towork with the electronics in thevehicle. If you add electrical partsor accessories, you could changethe way the engine operates.Before adding electricalequipment, check with yourdealer. If you do not, the enginemight not perform properly. Anyresulting damage would not becovered by the vehicle warranty.Engine Coolant HeaterVehicles with the engine coolantheater can use this optionin cold weather conditions at orbelow −18°C (0°F) for easierstarting and better fuel economyduring engine warm-up. Plug in thecoolant heater at least four hoursbefore starting your vehicle. Aninternal thermostat in the plug-endof the cord may exist which willprevent engine coolant heateroperation at temperaturesabove −18°C (0°F).To Use the Engine CoolantHeater1. Turn off the engine.2. Open the hood and unwrap theelectrical cord. The cord islocated near the driver side struttower.Remove the plastic cap toaccess the plug.
