VEHICLE CARE 2612. Keep turning the pressure capslowly and remove it. Open thesurge tank service port cap tothe lower chamber. The serviceport is behind the top chamber.3. Fill the surge tank top chamberwith the proper mixture to thebottom of the fill neck. The topchamber needs to be completelyfull. Fill the surge tank bottomchamber through the service portto approximately half.4. With the coolant surge tankpressure cap off and the surgetank service port cap open, startthe engine and let it run untilyou can feel the upper radiatorhose getting hot. Watch out forthe engine cooling fan(s).By this time, the coolant levelinside the coolant surge tank topchamber may be lower. If thelevel is lower, add more of theproper mixture to the surge tanktop chamber until the levelreaches the bottom of thefill neck.5. Replace the surge tank pressurecap tightly and close the surgetank service port cap.6. Check the level in the surge tanktop and bottom chambers whenthe cooling system has cooleddown. If the coolant is not at theproper levels, repeat Steps 1–6 and reinstall the pressure capand close the service port. If thecoolant still is not at the properlevels when the system coolsdown again, see your dealer.CautionIf the pressure cap is not tightlyinstalled, coolant loss and enginedamage may occur. Be sure the capis properly and tightly secured.Engine OverheatingThe vehicle has an indicator to warnof the engine overheating.If the decision is made not to lift thehood when this warning appears, getservice help right away.If the decision is made to lift thehood, make sure the vehicle is parkedon a level surface.Then check to see if the enginecooling fan is running. If the engine isoverheating, the fan should berunning. If it is not, do not continueto run the engine. Have the vehicleserviced.
