Chapter 1313-113.1 Error Code Table13.1.1 List of Error Codes 0011-2570iR2016J / iR2016 / iR2020 / / iR2016i / iR2020iT-13-113.2 Error Code Details13.2.1 Error Code Details 0011-2580iR2016J / iR2016 / iR2020 / / iR2016i / iR2020iMEMO:In case of iR2020i/iR2016i, the detail code of the error code of this machine can be confirmed in the following service mode.Service mode>ERROR DISPLAYT-13-2Error Code DetailCode Error Name/Explanation of ErrorE000 0000 Fixing temperature abnormal riseE001 0000 Fixing unit temperature rise detection (by main thermistor)0001 Fixing unit temperature rise detection (by sub thermistor)E002 0000 Fixing unit temperature insufficient riseE003 0000 Low fixing temperature detection after standby (by main thermistor)0001 Low fixing temperature detection after standby (by sub thermistor)E007 0000 Fixing film rotation errorE010 0000 Main motor rotation errorE019 0001 Waste toner full detection0002 Waster toner full detection sensor failureE052 0000 Duplex unit connection errorE100 0000 BD cycle out of rangeE197 0000 Erroneous communication with printer engineE500 0001 Finisher communication errorE520 0000 Offset errorE531 0000 Stapling errorE5400001 Paper surface not detected (standard tray)0002 Not moved within the specified time (standard tray)0003 Sensor not reached within 3 seconds (standard tray)0005 Encoder clock failure (standard tray)E5420001 Paper surface not detected (optional tray)0002 Not moved within the specified time (optional tray)0003 Sensor not reached within 3 seconds (optional tray)0005 Encoder clock failure (optional tray)E575 0000 Stack delivery errorE584 0000 Shutter failureE716 0000 Erroneous communication with optional cassetteE719 0000 Erroneous communication with card reader (serial communication)0002 Erroneous communication with coin vender (serial communication)E733 0000 Erroneous communication between controller and printerE736 0000 CCU communication errorE739 0000 Erroneous communication between controller and network boardE7440001 Language file/boot ROM/USB memory error000200030004E805 0000 Fan failureE808 0000 Fixing drive circuit failureDisplayCode Detail Code Main Cause/Symptom CountermeasureE000 0000 Startup errorThe temperature detected by the mainor sub thermistor does not rise to thespecified value during startup control.- Check the fixing film connector.- Replace the fixing film unit.- Replace the DC controller PCB.
