Chapter 1414-23T-14-1814.7.1.1.2 Detailed Discussions of Bit 70011-1862iR2016J / iR2016 / iR2020 / / iR2016i / iR2020iUse it to enable/disable placement of priority on recording in sub scanning direction.T-14-19*: Image B4 or shorter and that cannot be printed by division and on A4 recording paper.14.7.1.2 SSSW-SW1414.7.1.2.1 List of Functions0011-1884iR2016J / iR2016 / iR2020 / / iR2016i / iR2020iT-14-2014.7.1.2.2 Detailed Discussions of Bit 00011-1885iR2016J / iR2016 / iR2020 / / iR2016i / iR2020iSelect whether to enable or disable transfer bias pressure reduction mode.Select "Enable" to avoid image defects (black spots) produced by transfer bias leaks occurring in a low-pressure region, such as one at a high altitude. This settingregulates the transfer bias to keep it from exceeding a predetermined level during printing.14.7.1.2.3 Detailed Discussions of Bit 10011-1888iR2016J / iR2016 / iR2020 / / iR2016i / iR2020iSelect whether to enable or disable developing assembly idling mode. Select "Enable" to drive the main motor for a specified period of time to apply idling anddeveloping bias (AC + DC) to prevent the thinning of the image density when the unit is installed or the developing unit is replaced in a low-temperature, low-humidity region. This mode works only on a new developing assembly and before a toner cartridge is loaded.14.7.1.2.4 Detailed Discussions of Bit 20011-1889iR2016J / iR2016 / iR2020 / / iR2016i / iR2020iSelect whether to enable or disable black belt addition mode. If the user uses paper that causes fixed toner on paper to be fused and adhered to drum, selecting"Yes" will clean the drum by forming a black band on the drum surface during the reverse rotation which is performed after printing on 50 sheets.Implementation of this mode could result in a drum life falling short of its life expectancy.14.7.1.2.5 Detailed Discussions of Bit 30011-1890iR2016J / iR2016 / iR2020 / / iR2016i / iR2020iSelect whether to enable or disable post-rotation reduction mode. Selecting "Enable" will reduce the noise caused by the polygon motor by stopping the motorimmediately after post-rotation.14.7.1.2.6 Detailed Discussions of Bit 40011-1891iR2016J / iR2016 / iR2020 / / iR2016i / iR2020iBit Function 1 00 not used - -1 not used - -2 not used - -3 not used - -4 not used - -5 not used - -6 not used - -7 priority on recording in sub scanning direction place do not placeplace: if B4 recording paper and A4 recording paper are set and an A4 extra-long image(*) is received, printing will be on the B4 recording paper.do not place: if B5 horizontal recording paper and A4 recording paper are set and a B4 image isreceived, printing will be by division and on B5 horizontal recording paper.Bit Function 1 00 Transfer bias pressure reduction mode Enable Disable1 Developing assembly idling mode Enable Disable2 Black belt addition mode Enable Disable3 Post-rotation reduction mode Enable Disable4 Flicker reduction mode Enable Disable5 Silent mode Enable Disable6 Terminal temperature rise noise reduction mode Enable Disable7 Not used - -
