COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001CHAPTER 6 SELF DIAGNOSIS6-43 T1.4 Finisher-J1 Error CodesWhen the finisher’s self diagnostic mechanism has gone ON, it may be reset by turningoff and then on its host machine.While the finisher is out of order, prints can still be made by disabling the finisher opera-tion as follows (other than delivery):1) Service mode[1] Turn off and then on the main power switch.[2] Set '1' to SORTER>OPTION>MD-SPRTN.[3] Turn off and then on the main power switch.2) User mode[1] Turn off and then on the main power switch.[2] Set 'OFF' the following: 'adjustment/cleaning'>'staple/offset function'.[3] Turn off and then on the main power switch.E5000000 The communication between the copier and the finisher is disrupted and isnot corrected for 5 sec or less.Cause The copier harness is faulty. (disconnected connector, open circuit) The fin-isher controller PCB or the copier’s DC controller PCB is faulty.E5140000 At the start of the motor CW operation, the stack handling motor (M2) maybe driven for a specific number of rotations; however, the stack delivery le-ver home position sensor (S8) does not go ON.Cause The stack handling motor (M2) is faulty. The stack delivery lever home po-sition sensor (S8) is faulty, the connector is disconnected, or an open circuitexits. The stack handling motor (M2) relay harness is faulty. The returnroller is faulty.E5300000 The alignment motor (M4) is driven for a specific number of rotations, butthe aligning plate home position sensor (S7) does not go ON.The alignment motor (M4) is driven for a specific number of rotations, butthe aligning plate home position sensor (S7) does not go OFF.Cause The rear alignment motor (M4) is faulty. The rear aligning plate home posi-tion sensor (S7) is faulty. The rear alignment motor relay harness is faulty.The rear aligning plate is subjected to an excess load.
