3 Using a TCP/IP NetworkSettings Common to TCP/IPv4 and TCP/IPv6 3-23Settings Common to TCP/IPv4 and TCP/IPv6This section describes the procedure for specifying the settings common to TCP/IPv4 and TCP/IPv6using the control panel.Specify the settings required for your network environment. If you want to use both TCP/IPv4communications and TCP/IPv6 communications, specify the settings required for both protocols.After performing this procedure, follow the procedure in "Confirming TCP/IPv4 Settings(p.3-33)" and"Confirming TCP/IPv6 Settings(p.3-35)" to check whether the network settings are correct.1. On the TCP/IP Settings screen, press [LPD Print Settings] → specify thefollowing.Specify the LPD print settings if you are using the iR3245N/iR3235N/iR3225N, or theiR3245/iR3235/iR3225 with the optional UFR II Printer Kit, the optional UFR II/PCL PrinterKit, the optional PS Printer Kit, or the optional Super G3 FAX Board.[On]: You can use LPD as the print application.You can only output a banner page if you are using the iR3245N/iR3235N/iR3225N, or the iR3245/iR3235/iR3225 with the optional UFR II/PCL Printer Kit or the optional PS Printer Kit.Output of a banner page is set on a print-job basis. Even if [On] is selected for , abanner page cannot be output for a print job unless it is set.