Troubleshooting11‑20Message Description ActionPlace the original on theplaten glass.The specified mode requiresthat the original be placed onthe platen glass, but there is nooriginal on the platen glass.Place the original on the platenglass.Platen Glass is dirty. The feeder’s scanning area isdirty.Clean the feeder’s scanningarea. (See “Manual FeederCleaning,” on p. 10‑7.)Remove the original from thefeeder.The machine cannot scan youroriginal using the feeder. Anoriginal is placed in the feederand on the platen glass.Remove the original from thefeeder.Remove the paper from theoutput tray.Prints from the previous jobremain in the output tray.Remove the prints remainingin the output tray. Printingautomatically resumes.Replace the toner. Printing is not possible becausethe toner has run out.Replace the cartridge. (See“Replacing the Cartridge,” onp. 10‑14.)Return page 1 to the top, andthen press the Start key.Scanning was stopped due to aproblem with the feeder.Arrange the originals in pageorder with the first page ontop. Place the originals backinto the feeder’s original supplytray, and press (Start).Set the IP Address.(imageCLASS MF7480/MF7470 Only)This machine is not set with anIP address.Specify the IP Address Settingsin TCP/IP Settings in NetworkSettings in System Settings(from the Additional Functionsscreen), then turn themachine’s main power off andback on again. (See Chapter6, “Network (imageCLASSMF7480/MF7470 Only),” in theReference Guide, or “Set theMachine for Network Usage(imageCLASS MF7480/MF7470Only),” in the Starter Guide.)There are too manysubdirectories.You have exceeded themaximum number ofsubdirectory levels allowed.The directory level that youare trying to access cannot bespecified. Specify a differentdestination.
