Installing an Internal Solutions PortThe system board supports one optional Internal Solutions Port (ISP). Install an ISP for additional connectivity options.Note: This task requires a flathead screwdriver.CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memorydevices sometime after setting up the printer, then turn the printer off, and unplug the power cord from thewall outlet before continuing. If you have any other devices attached to the printer, then turn them off as well,and unplug any cables going into the printer.Warning—Potential Damage: System board electronic components are easily damaged by static electricity. Touchsomething metal on the printer before touching any system board electronic components or connectors.1 Access the system board.1232 Unpack the ISP and plastic tee.Note: Avoid touching the components on the card.3 Locate the appropriate connector on the system board.Note: If an optional printer hard disk is currently installed, then the printer hard disk must first be removed. Toremove the hard disk:Additional printer setup25
