Changing port settings after installing a newnetwork Internal Solutions PortWhen a new network Internal Solutions Port (ISP) is installed in the printer, the printer is assigned a new IP address.The printer configurations on computers that access the printer must be updated with this new IP address in orderto print to it over the network.Notes:• If the printer has a static IP address that will stay the same, then you do not need to make any changes to thecomputer configurations.• If the computers are configured to print to the printer by a network name that will stay the same, instead of byIP address, then you do not need to make any changes to the computer configurations.• If you are adding a wireless ISP to a printer previously configured for a wired connection, then make sure thewired network is disconnected when you configure the printer to operate wirelessly. If the wired connectionremains connected, then the wireless configuration will complete, but the wireless ISP will not be active. In theevent that the printer was configured for a wireless ISP while still attached to a wired connection, disconnectthe wired connection, turn the printer off, and then turn the printer back on again. This will enable the wirelessISP.• Only one network connection at a time is active. If you want to switch the connection type between wired andwireless, you must first turn the printer off, connect the cable (to switch to a wired connection) or disconnectthe cable (to switch to a wireless connection), and then turn the printer back on again.For Windows users1 Print a network setup page and make a note of the new IP address.2 Click , or click Start and then click Run.3 In the Start Search or Run box, type control printers.4 Press Enter, or click OK.The printer folder opens.5 Locate the printer that has changed.Note: If there is more than one copy of the printer, then update all of them with the new IP address.6 Right-click the printer.7 Click Properties.8 Click the Ports tab.9 Locate the port in the list, and then select it.10 Click Configure Port.11 Type the new IP address in the “Printer Name or IP Address” field. You can find the new IP address on the networksetup page you printed in step 1.12 Click OK, and then click Close.Additional printer setup48
