268 | Content Addressable Memory (CAM)w w w . d e l l . c o m | s u p p o r t . d e l l . c o m Reserved : 8K entries : 8K entriesFIB : 0 entries : 0 entriesACL : 0 entries : 0 entriesFlow : 0 entries : 0 entriesEgACL : 0 entries : 0 entriesMicroCode Name : Default : Default--More--View a brief output of the command show cam-profile using the summary option.The command show running-config cam-profile shows the current profile and microcode as shown in thefollowing example.FTOS#show running-config cam-profile!cam-profile default microcode defaultFTOS#View CAM-ACL settingsThe show cam-acl command is supported on platforms c sView the current cam-acl settings for the C-Series, S-Series and systems chassis and eachcomponent using the command show cam-acl, as shown in as shown in the following examples.The default values for the show cam-acl command for C-Series and S-Series are:FTOS# show cam-acl-- Chassis Cam ACL --Current Settings(in block sizes)L2Acl : 2Ipv4Acl : 2Ipv6Acl : 2Ipv4Qos : 2L2Qos : 2L2PT : 1IpMacAcl : 2VmanQos : 0VmanDualQos : 0EcfmAcl : 0-- Line card 0 --Current Settings(in block sizes)L2Acl : 2Ipv4Acl : 2Ipv6Acl : 2Ipv4Qos : 2Note: If you select the CAM profile from CONFIGURATION mode, the output of this command does notreflect any changes until you save the running-configuration and reload the chassis.
