IPv6 Routing | 457The default option sets the CAM Profile as follows:• L3 ACL (ipv4acl): 6• L2 ACL(l2acl): 5• IPv6 L3 ACL (ipv6acl): 0• L3 QoS (ipv4qos): 1• L2 QoS (l2qos): 1Save the new CAM settings to the startup-config (write-mem or copy run start) then reload the system forthe new settings to take effect.Assign an IPv6 Address to an InterfaceIPv6 Addresses are supported on platforms c e s zEssentially IPv6 is enabled in FTOS simply by assigning IPv6 addresses to individual router interfaces.IPv6 and IPv4 can be used together on a system, but be sure to differentiate that usage carefully. Use theipv6 address command to assign an IPv6 address to an interface.You can configure up to two IPv6 addresses on management interfaces, allowing required default routersupport on the management port that is acting as host as per RFC 4861. Data ports support more than twoIPv6 addresses.Command Syntax Command Mode Purposecam-acl { ipv6acl } CONFIGURATION Allocate space for IPV6 ACLs. Enter the CAMprofile name followed by the amount to beallotted.When not selecting the default option, you mustenter all of the profiles listed and a range for each.The total space allocated must equal 13.The ipv6acl range must be a factor of 2.show cam-acl EXECEXEC PrivilegeShow the current CAM settings.show cam-acl-egress CONFIGURATION Provides information on FP groups allocated forthe egress acl.You must allocate at least one group for L2ACLand IPv4 ACL.The total number of groups is 4.
