IPv6 Routing | 455SSH over an IPv6 TransportIPv6 SSH is supported on platforms c e s zFTOS supports both inbound and outbound SSH sessions using IPv6 addressing. Inbound SSH supportsaccessing the system through the management interface as well as through a physical Layer 3 interface.Refer to the Security chapter in the FTOS Command Line Reference Guide for SSH configuration details.Configuration Task List for IPv6This section contains information regarding the following:• Change your CAM-Profile on an E-Series system (mandatory)• Adjust your CAM-Profile• Assign an IPv6 Address to an Interface• Assign a Static IPv6 Route• Telnet with IPv6• SNMP over IPv6• Show IPv6 Information• Clear IPv6 RoutesChange your CAM-Profile on an E-Series systemThe cam-profile command is supported only on platform eChange your CAM profile to the CAM ipv6-extacl before doing any further IPv6 configuration. Once theCAM profile is changed, save the configuration and reboot your router.Figure 21-4 displays the IPv6 CAM profile summary for a chassis that already has IPv6 CAM profileconfigured. Figure 21-5 shows the full IPv6 CAM profiles. Refer to Chapter 10, Content AddressableMemory (CAM), on page 259 for complete information regarding CAM configuration.Command Syntax Command Mode Purposecam-profile ipv6-extaclmicrocode ipv6-extacl chassis| linecard slotEXEC Privileged Enable the CAM profile with IPv6 extended ACLson the entire chassis or on a specific linecardchassis changes the CAM profile for all linecardsin the chassislinecard slot/port changes the CAM profile only forthe specified slot
