Management | 71Recovering from a Forgotten Enable Password on the S4810and Z9000If you forget the enable password on the S4810:If you forget the enable password on the Z9000:12 Save the running-config. copy running-config startup-config EXEC PrivilegeStep Task Command Syntax Command Mode1 Log onto the system via console.2 Power-cycle the chassis by switching off all of the power modules and then switching them back on.3 Press any key to abort the bootprocess. You enter uBootimmediately on the S4810, asindicated by the => prompt.Note: You must enter the CLIcommands. The system will rejectthem if they are copied and pasted.Press any key (during bootup)4 Set the system parameters to ignorethe enable password when the systemreloads.setenv enablepwdignore true uBoot5 Save the environment. saveenv uBoot6 Reload the system. reset uBoot7 Configure a new enable password. enable {secret | password} CONFIGURATION8 Save the running-config to thestartup-config.copy running-config startup-config EXEC PrivilegeStep Task Command Syntax Command Mode1 Log onto the system via console.2 Power-cycle the chassis by switching off all of the power modules and then switching them back on.3 Press any key to abort the bootprocess. You enter grub on theZ9000, as indicated by the “grub>”prompt.Note: You must enter the CLIcommands. The system will rejectthem if they are copied and pasted.Press any key (during bootup)4 The Grub menu displays. Enter c to get to the Grub boot load command line prompt “grub>.”Step Task Command Syntax Command Mode
