506 | Intermediate System to Intermediate Systemw w w . d e l l . c o m | s u p p o r t . d e l l . c o m IPv6 routesUse these commands in ADDRESS-FAMILY IPV6 mode to apply prefix lists to incoming or outgoingIPv6 routes. =Note: These commands apply to IPv6 IS-IS only. Use the ROUTER ISIS mode previously shown to applyprefix lists to IPv4 routes.Command Syntax Command Mode Purposedis tribute-list prefix-list-name in [interface] ROUTER ISIS-AFIPV6Apply a configured prefix list to all incomingIPv6 IS-IS routes.Enter the type of interface and slot/portinformation:• For a 1-Gigabit Ethernet interface, enterthe keyword GigabitEthernet followed bythe slot/port information.• For the Loopback interface on the RPM,enter the keyword loopback followed by anumber from 0 to 16383.• For a port channel, enter the keywordport-channel followed by a number from1 to 255 for TeraScale, 1 to 32 forEtherScale.• For a SONET interface, enter the keywordsonet followed by slot/port information.• For a 10-Gigabit Ethernet interface, enterthe keyword TenGigabitEthernet followedby the slot/port information.• For a VLAN, enter the keyword vlanfollowed by a number from 1 to 4094.E-Series ExaScale platforms support4094 VLANs with FTOS version8.2.1.0 and later. Earlier ExaScalesupports 2094 VLANS.distribute-list prefix-list-name out [bgpas-number | connected | ospf process-id | rip |static]ROUTER ISIS-AFIPV6Apply a configured prefix list to all outgoingIPv6 IS-IS routes. You can configure one ofthe optional parameters:• connected : for directly connected routes.• ospf process-id: for OSPF routes only.• rip: for RIP routes only.• static : for user-configured routes.• bgp: for BGP routes onlydistribute-list redistributed-override in ROUTER ISIS-AFIPV6Deny RTM download for pre-existingredistributed IPv6 routes
