Monitoring and Alert Management 321where 1 and 1 are the e-mail destination index and the enable/disableselection, respectively.The e-mail destination index can be a value from 1 through 4.The enable/disable selection can be set to 1 (Enabled) or 0 (Disabled).For example, to enable e-mail with index 4, type the following command:racadm config -g cfgEmailAlert -ocfgEmailAlertEnable -i 4 13 Configure your e-mail settings.At the command prompt, type the following commandand press :racadm config -g cfgEmailAlert -ocfgEmailAlertAddress -i 1 where 1 is the e-mail destination index and is thedestination e-mail address that receives the platform event alerts.To configure a custom message, at the command prompt, type thefollowing command and press :racadm config -g cfgEmailAlert -ocfgEmailAlertCustomMsg -i 1 where 1 is the e-mail destination index and is themessage displayed in the e-mail alert.Testing E-mail AlertingThe RAC e-mail alerting feature allows users to receive e-mail alerts when acritical event occurs on the managed system. The following example showshow to test the e-mail alerting feature to ensure that the RAC can properlysend out e-mail alerts across the network.racadm testemail -i 2NOTE: Ensure that the SMTP and Email Alert settings are configured before testingthe e-mail alerting feature. See "Configuring E-Mail Alerts" on page 320 for moreinformation.
