Script Commands 177ParameterAdditional InformationThe RAID controller module that receives the reset RAID controller modulecommand resets the RAID controller module specified. For example, if thereset RAID controller module command is sent to RAID controller module 0to request a reset of RAID controller module 0, then RAID controller module0 reboots itself by doing a soft reboot. If the reset RAID controller modulecommand is sent to RAID controller module 0 to request a reset of RAIDcontroller module 1, then RAID controller module 0 holds RAID controllermodule 1 in reset and then releases RAID controller module 1 from reset,which is a hard reboot. A soft reboot in some products only resets the IOCchip. A hard reboot resets both the IOC chip and the expander chips in theRAID controller module.Reset Storage Array Battery Install DateThis command resets the age of the batteries in a storage array to zero days.You can reset the batteries for an entire storage array or just the battery for aspecific RAID controller module or in a specific battery pack.Syntaxreset storageArray batteryInstallDate controller=(0 | 1)Parameter Descriptioncontroller RAID controller module to reset. Valid RAID controllermodule identifiers are 0 or 1, where, 0 is the RAID controllermodule on the left and 1 is the RAID controller module onthe right when viewed from the rear of the enclosure. Youmust put brackets ([ ]) around the RAID controller moduleidentifier. If you do not specify an owner, the RAID controllermodule firmware returns a syntax error.
