178 Script CommandsParametersNOTE: If you do not specify a RAID controller module, the age is reset for thestorage array battery or both RAID controller module batteries. If you specify aRAID controller module, then the age for only that RAID controller module battery isreset.Reset Storage Array iSCSI BaselineThis command resets the iSCSI baseline for the storage array to 0.Syntaxreset storageArray iscsiStatsBaselineParametersNone.NOTE: This command resets the baseline to 0 for both RAID controller modules inthe storage array. The purpose of resetting both of the RAID controller modulebaselines is to help ensure that the counts are synchronized between the RAIDcontroller modules. If one RAID controller module resets but the second RAIDcontroller module does not reset, the host is informed that the RAID controllermodules are out of synchronization. The host is informed by the time stamps thatare reported with the statistics.Example-c "reset storageArray iscsiStatsBaseline;"Parameter Descriptioncontroller Specifies the RAID controller module that contains the batteryfor which to reset the age. Valid RAID controller moduleidentifiers are 0 or 1, where, 0 is the RAID controller module onthe left, and 1 is the RAID controller module on the right whenviewed from the rear of the enclosure. Use the controllerparameter only for RAID controller modules with batteries.
