250 Script CommandsParameterStart iSCSI DHCP RefreshThis command initiates a refresh of the DHCP parameters for the iSCSIinterface. If the configuration method for the interface is not set to DHCP,the procedure returns an error.Syntaxstart controller [(0 | 1)] iscsiHostPort [(1 | 2 |3 | 4)] dhcpRefreshParametersNOTE: This operation ends the iSCSI connections for the portal and brings downthe portal temporarily.Parameter Descriptionenclosure Identifies the enclosure to blink. Enclosure IDvalues are 0 to 99. You must put brackets ([ ])around the enclosure ID value.Parameter Descriptioncontroller The identifier letter of the RAID controller module that has theiSCSI host ports. Valid RAID controller module identifier values are0 or 1, where, 0 is the RAID controller module in slot 0, and 1 is theRAID controller module in slot 1.iscsi-host-portThe identifier of the port on the storage array on which you want torefresh the DHCP parameters. Enclose the iSCSI host port name insquare brackets ([ ]).
