314 | SRA 6.0 Administrator’s GuideConfiguring End Point Control for UsersTo configure the End Point Control profiles used by a local user, perform the following steps:Step 1 Navigate to the Users > Local Users page.Step 2 Click the configure icon next to the user to be configured for EPC. The Edit Local User windowis displayed.Step 3 Click the EPC tab. The EPC window is displayed.Step 4 Configure EPC user settings and add or remove device profiles, as explained in “Users > LocalUsers > Edit EPC Settings” on page 208.Users > Local GroupsThis section provides an overview of the Users > Local Groups page and a description of theconfiguration tasks available on this page.• “Users > Local Groups Overview” section on page 314• “Deleting a Group” section on page 315• “Adding a New Group” section on page 315• “Editing Group Settings” section on page 316• “Group Configuration for LDAP Authentication Domains” section on page 329• “Group Configuration for Active Directory, NT and RADIUS Domains” section on page 333• “Creating a Citrix Bookmark for a Local Group” on page 336For a description of global settings for local groups, see the “Global Configuration” section onpage 336.Users > Local Groups OverviewThe Users > Local Groups page allows the administrator to add and configure groups forgranular control of user access by specifying a group name and domain.Note that a group is automatically created when you create a domain. You can create domainsin the Portals > Domains page. You can also create a group directly from the Users > LocalGroups page.Figure 54 Users > Local Groups PageGroup memberships are split into two groups, ‘primary’ and ‘additional’.
