Log Configuration | 349Configuring the Mail ServerIn order to receive notification email and to enable to the One Time Password feature, it isimperative that you configure the mail server from the Log > Settings page. If you fail toconfigure your mail server prior to using the One Time Password feature, you will receive anerror message:For information about configuring the One Time Password feature, refer to “One TimePassword Overview” section on page 46.To configure the mail server, perform the following steps:Step 1 Log in to the SRA management interface using administrator credentials.Step 2 Navigate to Log > Settings.Step 3 Type the email address where you want logs sent to in the Email Events Logs to field.Step 4 Type the email address where you want alerts sent to in the Email Alerts to field.Step 5 Type the IP address for the mail server you will be using in the Mail Server field.Step 6 Type the email address for outgoing mail from your SRA appliance in the Mail From Addressfield.Step 7 Click Accept in the upper right-hand corner.Log > CategoriesThis section provides an overview of the Log > Categories page and a description of thevarious categories of event messages that can be viewed in the log. This page allows for eachcategory to be enabled or disabled by the administrator. This capability can be particularlyhelpful when used to filter the log during the debug process.Administrators can enable or disable check boxes for each of the following log categories:
