Steps1 Peel the tape that secures the display cable.2 Open the latch and disconnect the display cable.3 Remove the display cable from the routing guides on the palm-rest and keyboard assembly.4 Peel the tape that secures the antenna cables to the palm-rest and keyboard assembly.5 Remove the six screws (M2.5x5) that secure the left and right hinges to the system board, and the palm-rest and keyboard assembly.6 Peel off the tape securing the wireless antenna, and disconnect the antennas from the system board.7 Disconnect the display cable from the connector on the system board.8 Lift the palm-rest and keyboard assembly at an angle.9 Lift the hinges to release the palm-rest and keyboard assembly off the display assembly.10 Slide and remove the palm-rest and keyboard assembly off the display assembly.After performing all the preceding steps, you are left with display assembly.Installing the display assemblyPrerequisiteIf you are replacing a component, remove the existing component before performing the installation procedure.Removing and installing components 39
