Steps1 Place the display panel on a flat and clean surface.2 Connect the display cable to the connector at the back of the display panel and close the latch to secure the cable.3 Adhere the tape that secures the display cable to the back of the display panel.4 Turn the display panel over and place it on the display back-cover.5 Align the screw holes on the display panel with the screw holes on the display back-cover.6 Replace the eight screws (six M2.5x2.5 and two M2x2) that secure the display panel to the display back-cover.Next steps1 Installing the display bezel.2 Installing the display assembly.3 Installing the WLAN.4 Installing the battery.5 Installing the base cover.6 Installing the SD memory card.7 Follow the procedure in After working on your thin client.CameraRemoving the cameraPrerequisites1 Follow the procedure in Before working on your thin client.2 Removing the SD memory card.3 Removing the base cover.4 Removing the battery.5 Removing the WLAN.6 Removing the display assembly.7 Removing the display bezel.8 Removing the display panel.About this taskThe following image indicates the location of the camera and provides a visual representation of the removal procedure:Removing and installing components 59