Steps1 Place the power adapter port into the slot on the palm-rest and keyboard assembly.2 Replace the screw (M2x3) that secures the power adapter port to the palm-rest and keyboard assembly.3 Connect the power adapter cable to the system board and route the cable through the routing guide.4 Press the right hinge on to the system board, and palm-rest and keyboard assembly.5 Replace the three screws (M2.5x5) that secure the right hinge to the system board, and palm-rest and keyboard assembly.Next steps1 Installing the WLAN.2 Installing the battery.3 Installing the base cover.4 Installing the SD memory card.5 Follow the procedure in After working on your thin client.Display bezelRemoving the display bezelPrerequisites1 Follow the procedure in Before working on your thin client.2 Removing the SD memory card.3 Removing the base cover.4 Removing the battery.5 Removing the WLAN.6 Removing the display assembly.About this taskThe following image indicates the location of the display bezel and provides a visual representation of the removal procedure:52 Removing and installing components