Option DescriptionEnable Intel TurboBoost—This option is enabled by default.Power managementTable 10. Power ManagementOption DescriptionAC Behavior Allows you to enable or disable the thin client from turning on automatically when an AC adapter isconnected.• Wake on ACThis option is not set by default.Auto On Time Allows you to set the time at which the thin client must turn on automatically.The options are:• Disabled—default• Every Day• Weekdays• Select DaysThis option is not set by default.USB Wake Support Allows you to enable USB devices to wake the system from standby.• Enable USB Wake SupportThis option is not set by default.Wireless Radio Control If enabled, this feature sense the connection of the system to a wired network and subsequently disablethe selected wireless radios.• Control WLAN radio• Control WWAN radioWake on LAN/WLAN This option enables the thin client to power up from the off state when triggered by a special LAN signal.Wake-up from the Standby state is unaffected by this setting and must be enabled in the operatingsystem. This feature only works when the thin client is connected to AC power supply.• Disabled—Does not allow the system to power on by special LAN signals when it receives a wake-upsignal from the LAN or wireless LAN.• LAN Only—Allows the system to be powered on by special LAN signals.• LAN with PXE—A wake-up signal that is sent to the system in either the S4 or S5 sleep state,wakes, and boots the system to PXE immediately.Block Sleep This option minimizes AC power usage at times of peak demand.Peak Shift Allows you to block entering to sleep in operating system environment.Advanced Battery ChargeConfigurationThis option enables you to maximize the battery health. By enabling this option, your system uses thestandard charging algorithm and other techniques, during the nonwork hours to improve the batteryhealth.Primary Battery ChargeConfigurationAllows you to select the charging mode for the battery.72 System setup