Dell(conf)#1. Select a cam-acl action.CONFIGURATION modecam-acl [default | l2acl]NOTE: Selecting default resets the CAM entries to the default settings. Select l2acl to allocatethe desired space for all other regions.2. Enter the number of FP blocks for each region.EXEC Privilege modecam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos numberl2qos number l2pt number ipmacacl number vman-qos | vman-dual-qos numberecfmacl number ipv4pbr number openflow number | fcoe number iscsioptaclnumberNOTE: If the allocation values are not entered for the CAM regions, the value is 0.3. Execute the write memory, verify that the new settings will be written to the CAM on the next boot.EXEC Privilege modeshow cam-acl4. Reload the system.EXEC Privilege modereloadTest CAM UsageThe test cam-usage command is supported on the Z9000 platform.Use this command to determine whether sufficient CAM space is available to enable a service-policy.Create a Class Map with all required ACL rules, then execute the test cam-usage command in Privilegemode to verify the actual CAM space required. The Status column in the command output indicateswhether or not the policy can be enabled.Example of the test cam-usage CommandDell#test cam-usage service-policy input test-cam-usage stack-unit 7 po 0Stack-Unit | Portpipe | CAM Partition | Available CAM | Estimated CAM per Port| Status------------------------------------------------------------------------------------------7 | 0 | IPv4Flow | 192 | 3| Allowed (64)Dell#Content Addressable Memory (CAM) 233
