3. Assign the Primary and Secondary ports and the control VLAN for the ports on the ring.CONFIG-FRRP mode.interface primary int slot/port secondary int slot/port control-vlan vlan idInterface:• For a 10/100/1000 Ethernet interface, enter the keyword GigabitEthernet then the slot/portinformation.• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the slot/portinformation.• For a SONET interface, enter the keyword sonet then the slot/port information.• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/portinformation.• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/portinformation.Slot/Port, Range: Slot and Port ID for the interface. Range is entered Slot/Port-Port.VLAN ID: The VLAN identification of the control VLAN.4. Configure the Master node.CONFIG-FRRP mode.mode master5. Identify the Member VLANs for this FRRP group.CONFIG-FRRP mode.member-vlan vlan-id {range}VLAN-ID, Range: VLAN IDs for the ring’s member VLANS.6. Enable FRRP.CONFIG-FRRP mode.no disableConfiguring and Adding the Member VLANsControl and member VLANS are configured normally for Layer 2. Their status as Control or Member isdetermined at the FRRP group commands.For more information about configuring VLANS in Layer 2 mode, refer to the Layer 2 chapter.Be sure to follow these guidelines:• All VLANS must be in Layer 2 mode.• Tag control VLAN ports. Member VLAN ports, except the Primary/Secondary interface, can be taggedor untagged.• The control VLAN must be the same for all nodes on the ring.Force10 Resilient Ring Protocol (FRRP) 287
