The second bold lines indicate sFlow is enabled on linecards Gi 1/16 and Gi 1/17Dell#show sflowsFlow services are enabledGlobal default sampling rate: 32768Global default counter polling interval: 201 collectors configuredCollector IP addr: 133.33.33.53, Agent IP addr: 133.33.33.116, UDP port: 634377 UDP packets exported0 UDP packets dropped165 sFlow samples collected69 sFlow samples dropped due to sub-samplingLinecard 1 Port set 0 H/W sampling rate 8192Gi 1/16: configured rate 8192, actual rate 8192, sub-sampling rate 1Gi 1/17: configured rate 16384, actual rate 16384, sub-sampling rate 2Displaying Show sFlow on an InterfaceTo view sFlow information on a specific interface, use the following command.• Display sFlow configuration information and statistics on a specific interface.EXEC modeshow sflow interface interface-nameExample of Viewing sFlow Configuration (Interface)Example of the show running-config interface Command to View sFlow InformationDell#show sflow interface gigabitethernet 1/16Gi 1/16Configured sampling rate :8192Actual sampling rate :8192Sub-sampling rate :2Counter polling interval :15Samples rcvd from h/w :33Samples dropped for sub-sampling :6Dell#show running-config interface gigabitethernet 1/16!interface GigabitEthernet 1/16no ip addressmtu 9252ip mtu 9234switchportsflow enablesflow sample-rate 8192no shutdownDisplaying Show sFlow on a Stack-unitTo view sFlow statistics on a specified stack-unit, use the following command.• Display sFlow configuration information and statistics on the specified interface.EXEC modeshow sflow stack—unit slot-number748 sFlow
