3. Enter the disable command.LLDP-MANAGEMENT-INTERFACE mode.To undo an LLDP management port configuration, precede the relevant command with the keyword no.Advertising TLVsYou can configure the system to advertise TLVs out of all interfaces or out of specific interfaces.• If you configure the system globally, all interfaces send LLDPDUs with the specified TLVs.• If you configure an interface, only the interface sends LLDPDUs with the specified TLVs.• If you configure LLDP both globally and at interface level, the interface level configuration overridesthe global configuration.To advertise TLVs, use the following commands.1. Enter LLDP mode.CONFIGURATION or INTERFACE modeprotocol lldp2. Advertise one or more TLVs.PROTOCOL LLDP modeadvertise {dcbx-appln-tlv | dcbx-tlv | dot3-tlv | interface-port-desc |management-tlv | med }Include the keyword for each TLV you want to advertise.• For management TLVs: system-capabilities, system-description.• For 802.1 TLVs: port-protocol-vlan-id, port-vlan-id .• For 802.3 TLVs: max-frame-size.• For TIA-1057 TLVs:– guest-voice– guest-voice-signaling– location-identification– power-via-mdi– softphone-voice– streaming-video– video-conferencing– video-signaling– voice– voice-signalingIn the following example, LLDP is enabled globally. R1 and R2 are transmitting periodic LLDPDUs thatcontain management, 802.1, and 802.3 TLVs.474 Link Layer Discovery Protocol (LLDP)
