outbound ah sasspi : 500 (0x1f4)transform : ah-md5-hmacin use settings : {Transport, }replay detection support : NSTATUS : ACTIVEinbound esp sasoutbound esp sasInterface: TenGigabitEthernet 0/1Link Local address: fe80::201:e8ff:fe40:4d11IPSecv6 policy name: OSPFv3-1-600inbound ah sasoutbound ah sasinbound esp sasspi : 600 (0x258)transform : esp-des esp-sha1-hmacin use settings : {Transport, }replay detection support : NSTATUS : ACTIVEoutbound esp sasspi : 600 (0x258)transform : esp-des esp-sha1-hmacin use settings : {Transport, }replay detection support : NSTATUS : ACTIVETroubleshooting OSPFv3Dell Networking OS has several tools to make troubleshooting easier. Consider the following informationas these are typical issues that interrupt the OSPFv3 process.NOTE: The following troubleshooting section is not meant to be a comprehensive list, onlyexamples of typical troubleshooting checks.• Have you enabled OSPF globally?• Is the OSPF process active on the interface?• Are the adjacencies established correctly?• Did you configure the interfaces for Layer 3 correctly?• Is the router in the correct area type?• Did you include the routes in the OSPF database?• Did you include the OSPF routes in the routing table (not just the OSPF database)?Some useful troubleshooting commands are:• show ipv6 interfaces• show ipv6 protocols• debug ipv6 ospf events and/or packets• show ipv6 neighbors• show virtual links584 Open Shortest Path First (OSPFv2 and OSPFv3)
