C 601::/64 [0/0]Direct, Te 0/24, 00:34:18C 912::/64 [0/0]Direct, Lo 2, 00:02:33O IA 999::1/128 [110/2]via fe80::201:e8ff:fe8b:3166, Te 0/24, 00:01:30L fe80::/10 [0/0]Direct, Nu 0, 00:34:42Dell#Dell#show ipv6 route staticDestination Dist/Metric, Gateway, Last Change-----------------------------------------------------S 8888:9999:5555:6666:1111:2222::/96 [1/0]via 2222:2222:3333:3333::1, Gi 9/1, 00:03:16S 9999:9999:9999:9999::/64 [1/0]via 8888:9999:5555:6666:1111:2222:3333:4444, 00:03:16Showing the Running-Configuration for an InterfaceTo view the configuration for any interface, use the following command.• Show the currently running configuration for the specified interface.EXEC modeshow running-config interface type {slot/port}Enter the keyword interface then the type of interface and slot/port information:– For a 10/100/1000 Ethernet interface, enter the keyword GigabitEthernet then the slot/ portinformation.– For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the slot/ portinformation.– For the Management interface on the RPM, enter the keyword ManagementEthernet then theslot/port information.– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/portinformation.– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.Example of the show running-config interface CommandDell#show run int gi 2/2!interface GigabitEthernet 2/2no ip addressipv6 address 3:4:5:6::8/24shutdownDell#Clearing IPv6 RoutesTo clear routes from the IPv6 routing table, use the following command.• Clear (refresh) all or a specific route from the IPv6 routing table.EXEC modeclear ipv6 route {* | ipv6 address prefix-length}IPv6 Routing 397
